MFG-CV01-P02 | Block seating and guide-motion rehearsal
Concept training procedure draft · D1 · 29 October 2026
For the inert browser model only. Not an approved operating SOP. No physical work, production release or certification is authorised.
Equipment: MFG-CV01
Model: 1.0.0-concept
Source basis: Original authored concept; no approved customer/OEM SOP supplied.

01. Confirm equipment and task identity.
Evidence: MFG-CV01 · Conveyor changeover rig. Record draft D1 and model 1.0.0-concept.
HOLD if: Identity, source applicability or required evidence is missing or inconsistent.

02. Confirm the inert training boundary.
Evidence: For the inert browser model only. Not an approved operating SOP. No physical work, production release or certification is authorised.
HOLD if: Identity, source applicability or required evidence is missing or inconsistent.

03. Inspect PIN-01 and PIN-02 with the component picker.
Evidence: Both locating features must be identified before discussing seating.
HOLD if: Identity, source applicability or required evidence is missing or inconsistent.

04. Select GB-B2 and use Block lift.
Evidence: Separate the block in the model; this is a visual training motion.
HOLD if: Identity, source applicability or required evidence is missing or inconsistent.

05. Orbit below the lifted block.
Evidence: Inspect the open underside and illustrative receiver geometry.
HOLD if: Identity, source applicability or required evidence is missing or inconsistent.

06. Compare each receiver with the two locating pins.
Evidence: The geometry shows a relationship; source-defined clearance and fit remain unverified.
HOLD if: Identity, source applicability or required evidence is missing or inconsistent.

07. Return Block lift to zero.
Evidence: Record the assembled illustration without claiming a measured seated condition.
HOLD if: Identity, source applicability or required evidence is missing or inconsistent.

08. Use Guide travel and identify RAIL-L / RAIL-R.
Evidence: The channels translate the concept rails symmetrically; the belt stays stopped.
HOLD if: Identity, source applicability or required evidence is missing or inconsistent.

09. Inspect HW-01 and both carriages.
Evidence: The visible handwheel is a named reference; native pivot/coupling acceptance belongs to Jan.
HOLD if: Identity, source applicability or required evidence is missing or inconsistent.

10. Stop at the first-piece evidence gate.
Evidence: Require the approved setting and physical check criteria before any real acceptance.
HOLD if: Identity, source applicability or required evidence is missing or inconsistent.

11. Prepare the evidence record.
Evidence: Record observations, source revisions, holds, recovery and missing physical evidence; do not invent a result.
HOLD if: Identity, source applicability or required evidence is missing or inconsistent.

12. Request qualified review before reuse.
Evidence: Keep this draft unapproved until the task owner accepts the sources, geometry, criteria, permissions and revision.
HOLD if: Identity, source applicability or required evidence is missing or inconsistent.